Lincoln Town Car Door Panel Removal. There are only 2 bolts and one screw to the rear door. Set the screw aside so you don’t lose it.
2008 Lincoln Town Car Door Panel Removal The Door from t-h-e-door.blogspot.com
Remove screws on front, rear and center of front door trim panel. There are only 2 bolts and one screw to the rear door. Here is the procedure to remove the panel.
Then Remove The Door Panel By Inserting A Screwdriver In.
Had trouble releasing the window from the regulator. Position the floor air distribution duct on the plenum. Pry off the door panel with a door panel tool or a putty knife.
You Will Have To Remove The Two Screws That Hold The Door Closing Strap And The One Screw Behing The Interior Driver Door Handle.
Be careful to use the right size torqx screw driver so as you don't strip them. Install the 2 screws and plastic push fastener. 2) remove two torqx/star screws on left and right of door leather pull strap.
Lift The Door Panel Up And Off.
Using the trim pad removing tool or equivalent, pry. Remove the phillips screw at the bottom of the door panel. Snap out two door pull strap retaining screw covers.
Disconnect The Window Switch Wiring Harness.
Disconnect driver seat regulator control processor switch (driver door only) if equipped. Lift the door latch and remove the screw attaching it to the panel. Hold the door handle latch open and look for a fastening screw at the base of the latch.
Remove Screws On Front, Rear And Center Of Front Door Trim Panel.
You may need to hold the latch open in order to access the fastening screw. Gently pull the door panel off by first lifting the panel over the manual lock/ unlock nipple/ shaft. Remove the driver door panel.
